CNC Fórum

Thank you for sharing your knowledge, Rado. So the lever takes care of the mechanical clutch engagement, and at the same time the electrical activation of the feed motor. But does this happen at exactly the same moment, or does the lever activate the motor first, and then, moving the lever further t...

Hi all, The wedges are both in place now. I machined a special screw so that the wedge fits in correctly. I have two further questions. Maybe you guys can answer them. 1- It’s an all too basic question, but I’m not 100% sure… The push buttons below the table feed lever; are they for activating the s...

Hi Rado, That's a very good point. It can go deeper there; I was thinking the same... The big hole is deep enough, but the M8 threaded hole isn't, so I was thinking to just shorten the screw. Now it has about 40 mm of M8 threads, but when I make it 25 mm, it should fit. About the nut: I think you're...

@ Rado „you cannot use climb milling” :( Maybe I have to start looking for a new nut… Yes, of course. I was hoping they weren't worn, and that I just put them in the wrong way (like with the bronze nut). But yes, I have some bronze sheet material laying around. Thank you! ______________ @ Andrej Tha...

Hi all, OK, I get it. I moved the nut (see photo). Now I have 640 mm table movement, indeed. 
I just didn’t thought that there would be no compensation for backlash… Maybe the friction of the large table key helps in preventing the table to „walk away” during milling. _______ @Zverodoktor I didn’t k...

Hi Andrej,

Thank you for your reply!

Very useful website. I checked out the document you proposed, and found some information that comes in handy for me. But I couldn’t find information concerning the table drive.

Though, this manual is definitely worth reading; thank you.

Kind regards,
Broer

Ahoj, :) Obnovuji frézku TOS FA2V a při sestavování stolu narazím na určité potíže. Když jsem dostal stroj byl kompletně rozebrat a myslím, že některé části chybí. Všiml jsem si, že o tomto stroji je mezinárodně známo jen velmi málo; což ztěžuje montáž... Téměř všechny problémy jsem se setkávají mít...